displacement sensor cylinder Sold to Canada

This article mainly introduces:

Canada hydraulic cylinder,displacement sensor cylinder manufacturer,displacement sensor cylinder

(Canada displacement sensor cylinder,produced by Hengyu Hydraulic Co., Ltd）

displacement sensor cylinder are widely used in Canada，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed displacement sensor cylinder for customers from Canada.

Introduction to displacement sensor cylinder:

When the control pressure of the hydraulic system is too low, the displacement sensor cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

The definition of the minimum stable speed refers to the minimum movement speed of the displacement sensor cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the displacement sensor cylinder that undertakes different work has different requirements for the minimum stable speed.

The internal leakage of the displacement sensor cylinder should be prevented when the displacement sensor cylinder is used. The internal leakage of displacement sensor cylinder includes the leakage caused by excessive wear of displacement sensor cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

displacement sensor cylinder daily maintenance, should focus on checking whether the piston rod surface roughness and shape and position tolerance meet the technical requirements, if the piston rod bending should be calibrated to meet the requirements or according to the physical mapping, manufactured by a professional manufacturer. If the piston rod surface coating wear, slip damage, local spalling can be adopted to remove the coating, re-chrome surface processing process.

Answers to some questions about displacement sensor cylinder:

Is it good or bad for the hydraulic cylinder working in the limit stroke position?
It is not good for the hydraulic cylinder working in the limit stroke position. Generally, when the cylinder is used in the limit stroke, the oil in the cylinder will form a backflow back pressure impact on the piston and guide sleeve seals. If the limit is not accurate, it is easy to cause collision damage. It is recommended to leave a buffer of ten to twenty centimeters.

What is the function of the hinged cylinder of the shield machine?
The articulated cylinder is used for the shield when the radius of curvature is very small during the propulsion process, that is, for turning. For example, a propulsion section with a radius of curvature of R150 can only be turned using an articulated system due to the sensitivity of the shield body (i.e. the length of the shield body divided by its outside diameter). However, in the construction process, the use of articulated systems is not much.