tension cylinder Sold to Slovakia

This article mainly introduces:

Slovakia hydraulic cylinder,tension cylinder manufacturer,tension cylinder

(Slovakia tension cylinder,produced by Hengyu Hydraulic Cylinder Factory）

tension cylinder are widely used in Slovakia，because of long service life，high work efficiency，smooth movement.So our company has designed tension cylinder for customers from Slovakia.

Introduction to tension cylinder:

tension cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the tension cylinder head itself is the guide sleeve of the piston rod, the tension cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the tension cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

When the initial action of the tension cylinder is slow, please check the temperature of the hydraulic system, because in the case of low temperature, the viscosity of the hydraulic oil is large and the fluidity is poor, resulting in slow action of the tension cylinder. The improvement method is to replace the hydraulic oil with good viscosity temperature performance, and the oil temperature at low temperature can be increased by heater or heating by the machine itself, and the normal working oil temperature of the system should be maintained at about 40 ° C.

If the tension cylinder slips or crawls, please check whether there is astringency inside the tension cylinder, because the internal parts of the tension cylinder are improperly assembled, the parts are deformed, worn or the shape and position tolerance is excessive, the action resistance is too large, so that the piston speed of the tension cylinder changes with the different stroke position, and the slip or crawl occurs. Most of the reasons are due to poor assembly quality of parts, surface scars or sintered iron filings, so that the resistance increases, the speed decreases. For example, the piston is different from the piston rod or the piston rod is bent, the tension cylinder or the piston rod is offset from the mounting position of the guide rail, and the sealing ring is too tight or too loose. The solution is to repair or adjust, replace damaged parts and remove iron filings.

When installing the tension cylinder, the axial ends of the tension cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the tension cylinder, there is axial expansion. If the two ends of the tension cylinder are fixed, all parts of the tension cylinder will be deformed. When disassembling the tension cylinder, it is strictly forbidden to hammer the tension cylinder and the piston surface, such as the tension cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Answers to some questions about tension cylinder:

Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.

The difference between the overall cylinder and the separate cylinder of the truck?
The whole cylinder is cast in one piece, and such a cylinder generally does not leak oil. Split cylinder refers to two welded, easy to leak oil in the welding place, resulting in damage to the cylinder, or its body can not get up, many people do not use this kind of cylinder now.