constant speed cylinder Sold to Vietnam

This article mainly introduces:

Vietnam hydraulic cylinder,constant speed cylinder manufacturer,constant speed cylinder

(Vietnam constant speed cylinder,produced by Hengyu Hydraulic Cylinder Factory）

constant speed cylinder are widely used in Vietnam，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed constant speed cylinder for customers from Vietnam.

Introduction to constant speed cylinder:

When the constant speed cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the constant speed cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

In order to ensure the service life of the constant speed cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the constant speed cylinder, causing damage to the seal and causing leakage in the constant speed cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

constant speed cylinder use should try to avoid sealing belt into the constant speed cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the constant speed cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the constant speed cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

The repair method of the constant speed cylinder: the repair of the constant speed cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

Answers to some questions about constant speed cylinder:

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.

How long can a hydraulic cylinder work continuously?
If the maintenance is good, the service life can be extended a lot. The life of the cylinder is related to the structure of the cylinder, working pressure, stress state, hydraulic oil cleanliness, oil temperature control, maintenance and preventive measures. For example, the cylinder structure, the inner wall of the cylinder has quilting, rolling, chrome plating and other methods, the sealing parts have polyurethane rings, glay rings, metal sealing rings, etc., different combinations, the life difference is dozens of times. Metallurgical system is a typical cylinder application, in 24 hours of work, a year or more can not be shut down, in the middle of continuous work.