vehicle hydraulic cylinder Sold to New Zealand

This article mainly introduces:

New Zealand hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(New Zealand vehicle hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

vehicle hydraulic cylinder are widely used in New Zealand，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed vehicle hydraulic cylinder for customers from New Zealand.

Introduction to vehicle hydraulic cylinder:

When the vehicle hydraulic cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.

When the oil pressure of the vehicle hydraulic cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

In the process of using the vehicle hydraulic cylinder, sometimes such a problem will occur, the vehicle hydraulic cylinder can not act immediately after the instruction of the vehicle hydraulic cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil vehicle hydraulic cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Do not regularly check the damage of the chrome layer of the vehicle hydraulic cylinder: completely extend the vehicle hydraulic cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the vehicle hydraulic cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the vehicle hydraulic cylinder seal. Welding slag is strictly prohibited on the surface of the vehicle hydraulic cylinder.

Answers to some questions about vehicle hydraulic cylinder:

Is it normal for the cylinder to turn black?
Cylinder blackening is a soft fault: 1. It does not affect the normal operation of your equipment. 2. Cylinder blackening involves a lot of things: hydraulic oil, oil seal material, piston rod coating, etc. These three things are not determined by the manufacturer because these three things are provided by other manufacturers. If the equipment is not due to high temperature caused by the black cylinder, you do not have to worry too much because your excavator can still work normally. If you feel uncomfortable, you can choose to replace the cylinder or replace the hydraulic oil.

What is the meaning of cylinder ejection on the injection mold, and what is the difference between cylinder ejection and ordinary ejection?
Usually requires the front die ejection will use the cylinder to drive the thimble plate to achieve the ejection of the thimble. There is also a case that the mold is very large or long, and the balance of the ejector rod of the injection molding machine is not enough, and the cylinder ejector will also be used.