hydraulic servo cylinder Sold to Kuwait

This article mainly introduces:

Kuwait hydraulic cylinder,hydraulic servo cylinder manufacturer,hydraulic servo cylinder

(Kuwait hydraulic servo cylinder,produced by Hengyu Group）

hydraulic servo cylinder are widely used in Kuwait，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed hydraulic servo cylinder for customers from Kuwait.

Introduction to hydraulic servo cylinder:

The hydraulic servo cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the hydraulic servo cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the hydraulic servo cylinder wall due to the stiffness and the weight of the parts, causing scars.

When the hydraulic servo cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the hydraulic servo cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

The piston rod of the hydraulic servo cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.

Disassembly hydraulic servo cylinder: When disassembly hydraulic servo cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the hydraulic servo cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the hydraulic servo cylinder.

Answers to some questions about hydraulic servo cylinder:

Hydraulic cylinder load algorithm?
If it is thrust, load = working pressure x piston area. If it is pulling force, load = working pressure x(piston area - piston rod area).

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.