tilting furnace hydraulic cylinder Sold to Mexico

This article mainly introduces:

Mexico hydraulic cylinder,tilting furnace hydraulic cylinder manufacturer,tilting furnace hydraulic cylinder

(Mexico tilting furnace hydraulic cylinder,produced by Hengyu Group）

tilting furnace hydraulic cylinder are widely used in Mexico，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed tilting furnace hydraulic cylinder for customers from Mexico.

Introduction to tilting furnace hydraulic cylinder:

tilting furnace hydraulic cylinder installation precautions: Before installing the tilting furnace hydraulic cylinder into the system, the parameters on the tilting furnace hydraulic cylinder label should be compared with the parameters when ordering. The base of the tilting furnace hydraulic cylinder must have sufficient stiffness, otherwise the tilting furnace hydraulic cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

In order to ensure the service life of the tilting furnace hydraulic cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the tilting furnace hydraulic cylinder, causing damage to the seal and causing leakage in the tilting furnace hydraulic cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

When the oil pressure of the tilting furnace hydraulic cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

In use, the tilting furnace hydraulic cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the tilting furnace hydraulic cylinder.

Answers to some questions about tilting furnace hydraulic cylinder:

What is hydraulic cylinder guide?
The cylinder itself can not move, the piston moves, the guide should be used to guide the mechanism connected with the piston extension end. For example, in the commonly used hydraulic press, the guide column above is used to guide the pressure plate connected with the piston.

How to disassemble the big nut that excavate the oil cylinder piston of the excavator?
If you want to be safe, look for a special unloading place for this thing, which is an oil cylinder on top of a turntable with a large nut attached to the center of the turntable. If you're in the field just pin the head of the cylinder to one end, use a big homemade wrench to hold the nut in place, and then get a digging machine and push it down, and it opens.