Release time：2023-11-12 15:27:29 Hits： Current position: Home > News
This article mainly introduces:
Czech Republic hydraulic cylinder,road paving machine hydraulic cylinder manufacturer,road paving machine hydraulic cylinder
(Czech Republic road paving machine hydraulic cylinder,produced by Hengyu Group）
road paving machine hydraulic cylinder are widely used in Czech Republic，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed road paving machine hydraulic cylinder for customers from Czech Republic.
After the road paving machine hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.
The assembly work of the road paving machine hydraulic cylinder has a great impact on the quality of the road paving machine hydraulic cylinder: each part must be carefully cleaned before assembly; To correctly install the sealing device everywhere: when installing the sealing ring, pay attention to its installation direction to avoid oil leakage due to installation, and its lip should be equipped with a pressure oil chamber. In addition, because it is a YX-shaped sealing ring, it is necessary to pay attention to distinguish between shaft and hole use, do not install wrong; Because the sealing device is matched with the sliding surface, an appropriate amount of hydraulic oil should be applied during assembly; The special wrench should be used when the threaded coupling is tightened, and the torque should meet the standard requirements; After the piston and piston rod are assembled, it is necessary to measure whether the coaxiality and straightness on the full length are out of whack. After assembly, there should be no blocking sensation and uneven resistance when the piston assembly moves.
The definition of the minimum starting pressure of the road paving machine hydraulic cylinder refers to the minimum working pressure of the road paving machine hydraulic cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the road paving machine hydraulic cylinder parts and the size of the sealing friction.
The material of the sliding part of the road paving machine hydraulic cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.
100 tons press, the cylinder diameter is 250, how much pressure?
100 tons hydraulic press, if it is a single acting hydraulic cylinder, the required oil pressure is the nominal force divided by the cross-sectional area of the cylinder piston. One hundred tons of its pressure is 1000 kN (1000000N), the diameter of the cylinder is 250 mm, its area is the circular rate multiplied by the square of the radius, is 49062.5 square mm, and then the pressure divided by the area of the oil pressure is 20.38MPa. Therefore, a hydraulic pressure of 20.38 mpa is required for a 250 diameter cylinder to obtain 100 tons of pressure.
What are the four cylinders of the truck crane?
The four cylinders of the truck crane generally refer to the telescopic cylinder of the boom (to adjust the length of the boom), the variable amplitude cylinder of the boom (to adjust the elevation Angle of the boom), the horizontal telescopic cylinder of the support leg and the vertical cylinder of the support leg.
Add Wechat