steel mill cylinder Sold to Mexico

This article mainly introduces:

Mexico hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Mexico steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Mexico，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed steel mill cylinder for customers from Mexico.

Introduction to steel mill cylinder:

The commonly used buffer structure of the steel mill cylinder is composed of a piston boss and a steel mill cylinder head groove. When the piston moves close to the steel mill cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

Do not enter foreign bodies when installing the steel mill cylinder block. The place where the installation operation is carried out, the conditions are not good, and foreign bodies can be entered unconsciously. Therefore, the installation site must be cleaned up around, especially the place where the parts are placed must be cleaned, so that there is no dirt.

In recent years, the processing process of the steel mill cylinder generally adopts the rolling method, which is a pressure finishing processing, which uses the cold plastic characteristics of the metal at room temperature, and uses the rolling tool to exert a certain pressure on the surface of the workpiece, so that the surface metal of the workpiece produces plastic flow, and fills in the low concave trough of the original residue, and the roughness value of the workpiece surface is reduced. Due to the plastic deformation of the rolled surface metal, the surface tissue is cold hardened and the grain is fine, forming a dense fiber, and forming a residual stress layer, and the hardness and strength are increased, thus improving the wear resistance, corrosion resistance and compatibility of the workpiece surface. Rolling is a plastic machining method without cutting.

When the steel mill cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the steel mill cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

Answers to some questions about steel mill cylinder:

How big is the motor and oil pump for the 80 cylinder?
Pump motor selection is not only related to cylinder diameter but also speed system, it is recommended to provide system diagram and speed requirements, generally speaking, most of the 80 cylinder on the market is equipped with 3-4KW motor, 10-20 oil pump.

Loader arm fell badly, how to know which oil cylinder is leaking?
No matter which cylinder leakage the arm will drop, it is best to replace the oil seal, even if one cylinder is good, it will not last long, and it will drop the arm, so the two cylinders should be replaced at once.