metallurgical cylinder Sold to Ireland

This article mainly introduces:

Ireland hydraulic cylinder,metallurgical cylinder manufacturer,metallurgical cylinder

(Ireland metallurgical cylinder,produced by Hengyu Hydraulic Co., Ltd）

metallurgical cylinder are widely used in Ireland，because of no transmission clearance，high work efficiency，long service life.So our company has designed metallurgical cylinder for customers from Ireland.

Introduction to metallurgical cylinder:

Factors that should be considered when selecting the oil seal in the metallurgical cylinder: some specific factors should be taken into account when selecting the oil seal in the metallurgical cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: metallurgical cylinder diameter, piston rod diameter, piston rod and piston groove size, metallurgical cylinder working pressure, metallurgical cylinder movement speed, hydraulic system oil temperature and metallurgical cylinder working environment.

After the metallurgical cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

The metallurgical cylinder is mainly composed of body, piston, piston rod, metallurgical cylinder head, metallurgical cylinder bottom, piston rod head and related auxiliary devices. The piston divides the metallurgical cylinder into two chambers, and moves reciprocally in the metallurgical cylinder with the help of pressure oil. In order to improve its working effect, there is no sealing ring on the piston to eliminate internal leakage, where the piston rod passes through the metallurgical cylinder head, due to the existence of the gap, it is easy to produce external leakage phenomenon, and the dust can enter the metallurgical cylinder through the gap, so the sealing device and dust prevention reason are set. At the same time, in order to eliminate the influence of eccentric load on the work of the piston, all the metallurgical cylinders must be provided with a considerable length of guide sleeve at the extended end of the piston rod. In addition, in the case of faster piston movement, the phenomenon of mechanical collision between the piston and the metallurgical cylinder bottom and the metallurgical cylinder head is serious, so the buffer deceleration should be set at both ends of the metallurgical cylinder The working medium of the metallurgical cylinder: because it works at room temperature, the ordinary oil-type hydraulic oil can be selected; metallurgical cylinder sealing device: The use of Yx sealing ring, polyurethane (PU) and polytetrafluoroethylene (PTFE) materials combined to achieve a good sealing effect; Buffer mechanism of the metallurgical cylinder: The buffer structure of the metallurgical cylinder is to prevent the piston from colliding with the metallurgical cylinder head at the end of the stroke.

We can not just consider the price and ignore the quality when we purchase the metallurgical cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the metallurgical cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the metallurgical cylinder is not required.

Answers to some questions about metallurgical cylinder:

What is the pressure provided for a 63-bore cylinder with a pressure of 2 mpa?
2 mpa pressure is equivalent to 20 kg per square centimeter, 6.3 cm straight longitude, 3.15 cm radius, square, multiplied by, calculated an area of about 31.5 square centimeters, multiplied by 20 kg, the pressure is about 630 kg.

What are the reasons why the hydraulic cylinder action is slower than normal?
There are many factors that cause this problem. First, measure the pressure of the main system to see whether the pressure of the main system under the pressure state is consistent with the initial setting. Before measuring the pressure, it is best to check the hydraulic oil and suction oil filter and replace or clean it. Second, check the main relief valve of the reversing control multiway valve to see if there is damage or foreign matter blocking, and clean it. If your pump is a gear pump, the problem should generally be small. Second, look at traffic. There is no leakage in the cylinder, leakage in the reversing valve spool and so on.