yg series hydraulic cylinder Sold to Ghana

This article mainly introduces:

Ghana hydraulic cylinder,yg series hydraulic cylinder manufacturer,yg series hydraulic cylinder

(Ghana yg series hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

yg series hydraulic cylinder are widely used in Ghana，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed yg series hydraulic cylinder for customers from Ghana.

Introduction to yg series hydraulic cylinder:

The yg series hydraulic cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating motion (or swinging motion). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the yg series hydraulic cylinder is proportional to the effective area of the piston and the pressure difference between the two sides; The yg series hydraulic cylinder is basically composed of yg series hydraulic cylinder and yg series hydraulic cylinder head, piston and piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential.

In order to ensure the service life of the yg series hydraulic cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the yg series hydraulic cylinder, causing damage to the seal and causing leakage in the yg series hydraulic cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

When the hydraulic oil is not pumped into the yg series hydraulic cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the yg series hydraulic cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

The yg series hydraulic cylinder should be vented: when the yg series hydraulic cylinder is installed or parked for a long time to work again, the air will penetrate into the yg series hydraulic cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the yg series hydraulic cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the yg series hydraulic cylinder, the oil is best entered and discharged from the highest point of the yg series hydraulic cylinder. yg series hydraulic cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

Answers to some questions about yg series hydraulic cylinder:

How to distinguish large cavity and small cavity of excavator rod cylinder ?
Single rod piston cylinder is a form of cylinder that is used relatively most, and the boom, bucket, dozer shovel cylinder are all in this form. Among them, the rodless cavity is also called the large cavity, and the rodless cavity is also called the small cavity. Therefore, the cylinder cavity on the side with the exposed piston rod is the small cavity, and the cylinder cavity on the side without the exposed rod is the large cavity.

Why is a light cylinder less productive than a heavy cylinder at the same oil pressure?
f=ps Under the same pressure, the larger the area, the greater the output, but the maximum pressure can not exceed the system engineering pressure of the cylinder!