trailer hydraulic cylinder Sold to Ghana

This article mainly introduces:

Ghana hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Ghana trailer hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

trailer hydraulic cylinder are widely used in Ghana，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed trailer hydraulic cylinder for customers from Ghana.

Introduction to trailer hydraulic cylinder:

When the trailer hydraulic cylinder thrust is insufficient, check the hydraulic circuit for leaks. Including leakage of valves and hydraulic lines. The inspection method is to check and eliminate the leakage of the hydraulic connection line by manipulating the reversing valve. Also consider the relief valve. If the relief valve enters the dirt and jams the spool, so that the relief valve is normally open, the hydraulic oil will flow directly back to the tank through the relief valve bypass, resulting in no oil in the trailer hydraulic cylinder. If the load is too large, although the regulating pressure of the relief valve has reached the maximum rating, the trailer hydraulic cylinder still cannot get the thrust required for continuous action without action. If the regulating pressure is low, the pressure is insufficient to achieve the required vertebra force, which is manifested as insufficient thrust. Check and adjust the relief valve at this time.

In the process of using the trailer hydraulic cylinder, sometimes such a problem will occur, the trailer hydraulic cylinder can not act immediately after the instruction of the trailer hydraulic cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil trailer hydraulic cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

When the trailer hydraulic cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the trailer hydraulic cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

The trailer hydraulic cylinder is not the same as the trailer hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the trailer hydraulic cylinder can not be used as a high-power power component, but the trailer hydraulic cylinder can be used as a relatively large power component, or the trailer hydraulic cylinder system can be used.

Answers to some questions about trailer hydraulic cylinder:

What is a hydraulic cylinder assembly?
Assembly, which means aggregate. A series of parts or products, formed to achieve a specific function of the whole, the general term for this system is assembly. The hydraulic cylinder assembly is not a single hydraulic cylinder part, which can be used by connecting the hydraulic hose.

What is the relationship between medium cylinder and side cylinder ratio of forklift truck?
The middle cylinder and the side cylinder seem to have no relationship, as long as the lifting speed required by the design can be ensured, but the diameter of the cylinder can not be too thin, so as to avoid the middle cylinder acting first when the high gantry vibration lifting, and then the two cylinders acting again.