unidirectional cylinder Sold to Bangladesh

This article mainly introduces:

Bangladesh hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

(Bangladesh unidirectional cylinder,produced by Hebei Hengyu company）

unidirectional cylinder are widely used in Bangladesh，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed unidirectional cylinder for customers from Bangladesh.

Introduction to unidirectional cylinder:

If the seal of the unidirectional cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

unidirectional cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the unidirectional cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the unidirectional cylinder. c. The unidirectional cylinder seal is extruded, if the O-ring is obviously extruded at the unidirectional cylinder seal, replace the unidirectional cylinder seal.

unidirectional cylinder and hydraulic station selection: Select the type and structure of the unidirectional cylinder according to the operation requirements of the main engine. According to the external load force borne by the unidirectional cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the unidirectional cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the unidirectional cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the unidirectional cylinder, the diameter of the piston and the piston rod.

Improve the service life of the unidirectional cylinder: it is necessary to maintain the normal clearance of the combined surface of the hydraulic components. When manufacturing or repairing the main parts of the unidirectional cylinder (such as the unidirectional cylinder block, piston rod, etc.), the assembly should be carried out in accordance with the tolerance lower limit of the assembly size, which can well reduce the occurrence of cavitation. If cavitation has occurred in the hydraulic components, only metallographic sandpaper polishing technology can be used to remove cavitation pitting and surface carbon deposits, and general fine sandpaper must not be used for polishing After the unidirectional cylinder is repaired, the hydraulic system should run smoothly for a certain period of time so that the hydraulic oil in the hydraulic system can be fully circulated; If necessary, the unidirectional cylinder inlet pipe (or return pipe) can be disassembled. Make the hydraulic oil overflow to achieve the effect of single unidirectional cylinder exhaust.

Answers to some questions about unidirectional cylinder:

Does the sealing string of the upper and lower chamber of the hydraulic cylinder fall by itself?
It is possible, the probability accounts for 85% (depending on the weight), the weight is less than the system resistance, may not fall, the weight is greater than the system resistance, will not necessarily fall, so often check the equipment, safety first, find the problem in time to solve, the cylinder is not very expensive parts, maintenance does not cost much money, However, accidents caused by cylinder failure will lose several times the cost.

How to distinguish large cavity and small cavity of excavator rod cylinder ?
Single rod piston cylinder is a form of cylinder that is used relatively most, and the boom, bucket, dozer shovel cylinder are all in this form. Among them, the rodless cavity is also called the large cavity, and the rodless cavity is also called the small cavity. Therefore, the cylinder cavity on the side with the exposed piston rod is the small cavity, and the cylinder cavity on the side without the exposed rod is the large cavity.