tailboard balance cylinder Sold to Britain

This article mainly introduces:

Britain hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder

(Britain tailboard balance cylinder,produced by Hengyu Hydraulic Co., Ltd）

tailboard balance cylinder are widely used in Britain，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed tailboard balance cylinder for customers from Britain.

Introduction to tailboard balance cylinder:

The tailboard balance cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the tailboard balance cylinder, bite. Elimination method: When installing the tailboard balance cylinder, ensure that the axis position of the tailboard balance cylinder is consistent with the direction of movement; Make the load borne by the tailboard balance cylinder as far as possible through the tailboard balance cylinder axis, to avoid the phenomenon of eccentricity.

How to repair the tailboard balance cylinder body when it is damaged: When the tailboard balance cylinder has trace deformation and shallow tensile marks, the tailboard balance cylinder is repaired by strong honing process. The heavy honing process can repair tailboard balance cylinders up to 2.5 times out of tolerance than the original tolerance. It honed the parts with excessive size or shape error through a powerful honing machine, so that the overall size, shape tolerance and roughness of the tailboard balance cylinder can meet the technical requirements.

When the tailboard balance cylinder is in use, ensure that the tailboard balance cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

The "O" ring can be used as an auxiliary seal inside the tailboard balance cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the tailboard balance cylinder, and can be completely sealed.

Answers to some questions about tailboard balance cylinder:

How big is the 100t cylinder pump and how big is the motor?
Load is calculated at 15 tons, stroke is calculated at 100 (both take the maximum) 15 tons = 15,000 kg, 15,000/210 bar (21 mpa) =71.42 square centimeters (cylinder area) 71.42/3,14 In the root *2=90,5 the inner diameter of the cylinder can be taken 100 mm. Travel 100 cm, that is, one meter, assuming 10, seconds a back and forth, then it is six times a minute, six meters per minute, then the required flow is,71,42*600 cm (6 meters) =42840 mm =42.84 liters/minute 42.84*21/60=14.9 kilowatts can choose 1450 RPM 4-stage motor 15KW.

Is there a way to make the cylinder stop pushing when it hits something hard during the process of pushing?
The simplest solution is to press the stop switch, this switch has a mechanical type, touch the object on the action or send a stop signal, through the operation of the motor control cylinder; There is also an induction switch, that is, when the hydraulic cylinder expands to the range of the induction switch can sense the signal, it sends a signal to let the motor act, resulting in the corresponding action of the cylinder.