tilting furnace hydraulic cylinder Sold to Egypt

This article mainly introduces:

Egypt hydraulic cylinder,tilting furnace hydraulic cylinder manufacturer,tilting furnace hydraulic cylinder

(Egypt tilting furnace hydraulic cylinder,produced by Hengyu Group）

tilting furnace hydraulic cylinder are widely used in Egypt，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed tilting furnace hydraulic cylinder for customers from Egypt.

Introduction to tilting furnace hydraulic cylinder:

The coordination of the sliding parts of the tilting furnace hydraulic cylinder itself should not be too tight, the sealing friction force should not be too large, and H8 / f8 coordination should be selected between the piston rod and the guide sleeve; Check whether the size of the sealing ring is processed strictly according to the standard; If the V-shaped sealing ring is used, the sealing friction should be adjusted to a moderate degree.

The material, shape and compression of the tilting furnace hydraulic cylinder seal have a great impact on the service life and work efficiency of the tilting furnace hydraulic cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

When the tilting furnace hydraulic cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the tilting furnace hydraulic cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

tilting furnace hydraulic cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the tilting furnace hydraulic cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the tilting furnace hydraulic cylinder. c. The tilting furnace hydraulic cylinder seal is extruded, if the O-ring is obviously extruded at the tilting furnace hydraulic cylinder seal, replace the tilting furnace hydraulic cylinder seal.

Answers to some questions about tilting furnace hydraulic cylinder:

What is the difference between hollow and solid oil cylinders?
Hollow solid cylinder, according to conventional understanding, refers to whether the piston rod is solid or hollow. General ordinary hydraulic cylinder, the piston rod is solid structure. Hollow hydraulic cylinder refers to a hollow piston rod structure of the hydraulic cylinder, see the attached figure. Piston rod hollow function: 1, the piston rod hollow, the middle can be threaded rod. For example, the clamping cylinder with a sawing machine, the piston rod center threading rod, part of the stroke through manual, part of the stroke hydraulic automatic walk. 2, the hollow hole of the piston rod can be used to direct the oil circuit to achieve special oil circuit. 3, the cylinder is relatively large, the piston rod is relatively large, and the stroke is longer, in this case, the piston rod is hollow to reduce the movement friction and lateral force.

How to distinguish loader boom and forearm hydraulic cylinder? Is it the upper arm or the lower arm?
The one in the middle that can flip the bucket is the small arm cylinder you say, and the one that lifts the brackets (big arms) on both sides is the big arm cylinder.