steering cylinder Sold to Japan

This article mainly introduces:

Japan hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Japan steering cylinder,produced by Hengyu Group）

steering cylinder are widely used in Japan，because of no transmission clearance，powerful torque，excellent temperature resistance.So our company has designed steering cylinder for customers from Japan.

Introduction to steering cylinder:

Regular maintenance of the steering cylinder includes: regular tightening, steering cylinder fastening screws and gland screws, steering cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the steering cylinder once a year. Clean regularly, the steering cylinder is cleaned every other year, and the seals are replaced while cleaning.

The piston seal of the steering cylinder is the main element to prevent leakage in the steering cylinder. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

When the steering cylinder is in use, ensure that the steering cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

The daily inspection of the steering cylinder includes: checking the connection of the steering cylinder and the pipe joint for leaks. Check the steering cylinder rod for leaks. Check the steering cylinder connection for leaks. When the steering cylinder moves, the work is normal and smooth. Whether the steering cylinder has internal leakage.

Answers to some questions about steering cylinder:

How to use a solenoid valve to control the expansion of a cylinder? Doesn't the solenoid valve only control on/off?
Use the solenoid valve P into A-B (generally equipped with oil circuit board) to connect the oil inlet interface at both ends of the cylinder, and the solenoid valve can be realized by power off (refer to the solenoid valve 2B2L, different solenoid valve actions are different).

How to distinguish loader boom and forearm hydraulic cylinder? Is it the upper arm or the lower arm?
The one in the middle that can flip the bucket is the small arm cylinder you say, and the one that lifts the brackets (big arms) on both sides is the big arm cylinder.