sanitation truck hydraulic cylinder Sold to Luxembourg

This article mainly introduces:

Luxembourg hydraulic cylinder,sanitation truck hydraulic cylinder manufacturer,sanitation truck hydraulic cylinder

(Luxembourg sanitation truck hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

sanitation truck hydraulic cylinder are widely used in Luxembourg，because of no need for deceleration device，long service life，smooth movement.So our company has designed sanitation truck hydraulic cylinder for customers from Luxembourg.

Introduction to sanitation truck hydraulic cylinder:

How the cavitation of the sanitation truck hydraulic cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the sanitation truck hydraulic cylinder, resulting in corrosive damage to the parts.

The piston rod of the sanitation truck hydraulic cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.

Most of the failure of the sanitation truck hydraulic cylinder is because there is a foreign body in the sanitation truck hydraulic cylinder into the failure of the sanitation truck hydraulic cylinder, the most problematic is that it is difficult to determine when the foreign body is into the sanitation truck hydraulic cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

In use, the sanitation truck hydraulic cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the sanitation truck hydraulic cylinder.

Answers to some questions about sanitation truck hydraulic cylinder:

Is there a way to make the cylinder stop pushing when it hits something hard during the process of pushing?
The simplest solution is to press the stop switch, this switch has a mechanical type, touch the object on the action or send a stop signal, through the operation of the motor control cylinder; There is also an induction switch, that is, when the hydraulic cylinder expands to the range of the induction switch can sense the signal, it sends a signal to let the motor act, resulting in the corresponding action of the cylinder.

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.