supporting cylinder Sold to Saudi Arabia

This article mainly introduces:

Saudi Arabia hydraulic cylinder,supporting cylinder manufacturer,supporting cylinder

(Saudi Arabia supporting cylinder,produced by Hengyu Group）

supporting cylinder are widely used in Saudi Arabia，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed supporting cylinder for customers from Saudi Arabia.

Introduction to supporting cylinder:

The method of sleeve supporting cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the supporting cylinder can be significantly improved by rolling in the finishing of the inner holes of the supporting cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.

When purchasing the supporting cylinder, try to clarify the following parameters of the supporting cylinder: A. supporting cylinder diameter, rod diameter, stroke; B. Working pressure or supporting cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right supporting cylinder type can be found accurately and quickly.

When the control pressure of the hydraulic system is too low, the supporting cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

At the rated pressure, the thrust of the supporting cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the supporting cylinder is related to the diameter of the supporting cylinder, but not to the stroke of the supporting cylinder. Moreover, the larger the supporting cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the supporting cylinder.

Answers to some questions about supporting cylinder:

What type of seal is the cylinder of shaft 50?
You won't know the exact model until you take it apart. Oil seals have O, Y, Yx, KYx, U, UN, UHS, YA, St, Gray, Yamagata, Lei type, etc. It is difficult to know what kind of oil seal the designer chooses. Cylinder oil seal installation method: 1. Receive a fixed number of oil seals. 2. From receiving the oil seal to assembly, it must be kept clean. 3. Before assembly, check the oil seal and measure whether the size of each part of the oil seal is consistent with the size of the shaft and cavity. Before the oil seal is installed, the size of the shaft diameter should be clearly compared with the inner diameter of the oil seal. The inner cavity size should be suitable for the outer diameter width of the oil seal. Check the lip of the oil seal for damage.

How to store hydraulic cylinder?
After cleaning the hydraulic cylinder with diesel or kerosene, apply lubricating oil and wrap it in oil paper, preferably in a wooden box, and store it in a dry and non-corrosive environment. The outer surface and inner surface of the hydraulic cylinder are sprayed with diesel oil, and the inner layer is covered with cloth and the outer coating of anti-rust oil is good. Put it in a dry place, clean it with diesel oil, and then apply a layer of anti-rust inside and outside the butter.