servo cylinder Sold to Paraguay

This article mainly introduces:

Paraguay hydraulic cylinder,servo cylinder manufacturer,servo cylinder

(Paraguay servo cylinder,produced by Hengyu Group）

servo cylinder are widely used in Paraguay，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed servo cylinder for customers from Paraguay.

Introduction to servo cylinder:

Before purchasing the servo cylinder, it is necessary to master the original information and design basis, mainly including: the use and working conditions of the machine; The structural characteristics, load conditions, stroke size and operation requirements of the working mechanism; The selected working pressure and flow of the hydraulic system; The reality of materials, fittings and processes; Relevant national standards and technical specifications, etc.

When the servo cylinder wear is serious, you can try to use an alloy scraper to shave grooves with a depth of more than 1mm on the surface of the slip injury, then clean the grooves with acetone, apply the adjusted TS311 anti-wear repair agent on the polished surface with the servo cylinder inner diameter copying plate, and scrape it flat vigorously to ensure compaction and higher than the inner surface of the servo cylinder. After curing, polish to leave a finishing margin. Finally, the overall size, shape tolerance and roughness of the servo cylinder can meet the requirements by grinding. However, the life and reliability of this repair servo cylinder are not high.

Before the servo cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

If the seal of the servo cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

Answers to some questions about servo cylinder:

What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.

What does cylinder hob125*100 mean?
HOB is a series of hydraulic cylinder products, the use of pressure 14MPA, tie rod structure. 125 refers to the diameter of the cylinder and 100 refers to the stroke. The unit is millimeters.