hydraulic hollow cylinder Sold to Ethiopia

This article mainly introduces:

Ethiopia hydraulic cylinder,hydraulic hollow cylinder manufacturer,hydraulic hollow cylinder

(Ethiopia hydraulic hollow cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic hollow cylinder are widely used in Ethiopia，because of no need for deceleration device，long service life，smooth movement.So our company has designed hydraulic hollow cylinder for customers from Ethiopia.

Introduction to hydraulic hollow cylinder:

The hydraulic hollow cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure hydraulic hollow cylinder can use 20 steel pipe, and the high pressure hydraulic hollow cylinder can use 45 steel pipe.

hydraulic hollow cylinder piston rod material selection and technical requirements: (I), because there is no special requirements, so use 45 steel as the piston rod material, the design of the piston rod only withstand pressure stress, so no modulation processing; (ii) The coaxial tolerance of the shaft journal and the outer circle of the mounting piston is not greater than 0.01mm, so as to ensure the coaxial degree of the outer circle of the piston rod and the outer circle of the piston, and avoid the stuck phenomenon of the piston and the hydraulic hollow cylinder, the piston rod and the guide. The vertical tolerance between the end face of the mounting piston and the axis of the piston rod is not more than 0.04mm/100mm to ensure that the piston installation does not produce skew; (iii) The outer circle of the piston rod should pay attention to the roughness; (iv) Because it is operated under low load conditions, surface treatment is omitted.

hydraulic hollow cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards hydraulic hollow cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the hydraulic hollow cylinder guide is determined by the length of the stroke. Check the strength of hydraulic hollow cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

Under normal circumstances, the hydraulic hollow cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the hydraulic hollow cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the hydraulic hollow cylinder and the end cover, the piston and the piston rod, the piston and the hydraulic hollow cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the hydraulic hollow cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

Answers to some questions about hydraulic hollow cylinder:

What is the reason for the hydraulic cylinder sticking out and not retracting?
There are two reasons: First, the problem with the seal, if there are two seals on the piston, the top seal is broken. Second, when the hydraulic pressure itself is designed, the rod cavity area is too small, so that the desired return force can not be achieved during the return trip. You can first check whether the coupling is damaged; Then see if the relief valve in the oil line block is blocked. If the use time is too long, it needs to be cleaned, the hydraulic oil is very dirty and can block oil block. Electromagnetic directional valves can also be checked, but the chance of problems is relatively small, unless there is a product problem.

What is the material of the lift cylinder?
The cylinder is composed of many parts. The cylinder also contains the seal and the installation port at both ends, the material of these two parts is not easy to determine if there is no physical object. The cylinder body is generally 20 steel, 45 steel, 27SiMn and other materials, and the piston rod is generally 40Cr, 45 steel and other materials.