Release time：2023-11-24 16:13:43 Hits： Current position: Home > News
This article mainly introduces:
Kazakhstan hydraulic cylinder,synchronous hydraulic cylinder manufacturer,synchronous hydraulic cylinder
(Kazakhstan synchronous hydraulic cylinder,produced by Hebei Hengyu company）
synchronous hydraulic cylinder are widely used in Kazakhstan，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed synchronous hydraulic cylinder for customers from Kazakhstan.
At the rated pressure, the thrust of the synchronous hydraulic cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the synchronous hydraulic cylinder is related to the diameter of the synchronous hydraulic cylinder, but not to the stroke of the synchronous hydraulic cylinder. Moreover, the larger the synchronous hydraulic cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the synchronous hydraulic cylinder.
The method of sleeve synchronous hydraulic cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the synchronous hydraulic cylinder can be significantly improved by rolling in the finishing of the inner holes of the synchronous hydraulic cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.
After the synchronous hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.
The repair method of synchronous hydraulic cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.
Where is the cylinder used? What is it used for? Can it be used in cars?
Cylinders can be used as actuator in hydraulic system. Such as hydraulic jacks, dump truck box lifting device, dodging (snow) machine loader bucket lifting device. Hydraulic cylinders are also widely used in car cranes. It's all about cars.
Why does the hydraulic cylinder go up to the top and then slowly go down?
Leakage in the cylinder or the hydraulic valve that controls the cylinder, can be replaced and removed. Or add a pressure retaining valve to the hydraulic system to ensure pressure.
Add Wechat