supporting cylinder Sold to Ireland

This article mainly introduces:

Ireland hydraulic cylinder,supporting cylinder manufacturer,supporting cylinder

(Ireland supporting cylinder,produced by Hengyu Group）

supporting cylinder are widely used in Ireland，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed supporting cylinder for customers from Ireland.

Introduction to supporting cylinder:

After chrome plating of the piston rod of the supporting cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

supporting cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the supporting cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the supporting cylinder. c. The supporting cylinder seal is extruded, if the O-ring is obviously extruded at the supporting cylinder seal, replace the supporting cylinder seal.

The quality of the supporting cylinder can not be ignored in the purchase of the supporting cylinder. The supporting cylinder is the main component of the supporting cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. supporting cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of supporting cylinder is deep hole processing, which has always troubled the processing personnel.

supporting cylinder abnormal sound, hysteresis phenomenon cause and elimination method: the piston rod is extended with abnormal sound and hysteresis, if the supporting cylinder is placed for a period of time, the supporting cylinder may enter the air, and the movement can be normal after dozens of repeated movements. If it still cannot be eliminated, check whether the load is aligned with the axis of the piston rod; Retracted piston rod installation helps to align the load with the piston rod. If the flow is unstable, it will also lead to abnormal movement of the piston rod. Check the relevant components of the hydraulic system.

Answers to some questions about supporting cylinder:

Why should the piston rod of the hydraulic cylinder be so precise? If you hope the cylinder has a long service cycle, then all parts need to be high-precision, not only the piston rod, but also the cylinder, the sealing groove, the surface roughness, the cylinder looks very simple. Any hydraulic factory can produce the cylinder, but the good cylinder is difficult to produce.

How to deal with hydraulic cylinder inner wall rag, local wear serious or corrosion?
It can be reparied if the inner wall of the hydraulic cylinder is frayed, local wear or corrosion. We can use the inner wall cold melting copper technology, it has the following advantages: first, the temperature is low, the operating temperature is less than 180 degrees, and the heat affected zone is small. Second: high hardness is up to Brinell hardness 280, wear resistance and anti-corrosion. Third: the process is mature, some large coal mills have been repaired with this method and the effect is remarkable.