vehicle hydraulic cylinder Sold to Estonia

This article mainly introduces:

Estonia hydraulic cylinder,vehicle hydraulic cylinder manufacturer,vehicle hydraulic cylinder

(Estonia vehicle hydraulic cylinder,produced by Hebei Hengyu company）

vehicle hydraulic cylinder are widely used in Estonia，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed vehicle hydraulic cylinder for customers from Estonia.

Introduction to vehicle hydraulic cylinder:

When the vehicle hydraulic cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

vehicle hydraulic cylinders in series, parallel and series parallel. Series: In the vehicle hydraulic cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the vehicle hydraulic cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the vehicle hydraulic cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the vehicle hydraulic cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

Most of the failure of the vehicle hydraulic cylinder is because there is a foreign body in the vehicle hydraulic cylinder into the failure of the vehicle hydraulic cylinder, the most problematic is that it is difficult to determine when the foreign body is into the vehicle hydraulic cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Disassembly vehicle hydraulic cylinder: When disassembly vehicle hydraulic cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the vehicle hydraulic cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the vehicle hydraulic cylinder.

Answers to some questions about vehicle hydraulic cylinder:

What is the material of the cylinder support ring?
Generally, it is polytetrafluoroethylene doped with copper powder, or polyformaldehyde, and copper sleeves, there are also nylon, resin and so on.

What is the bearing capacity of the HOB cylinder?
The normal specification of HOB is 140 kg pressure, which is more commonly used in the market, and there are clear marks on the cylinder, 210 kg is a strengthened version of HOB, generally customized cylinders are also clearly marked on the above, when the specific use of the cylinder, the maximum use pressure is marked on the cylinder.