steering cylinder Sold to Indonesia

This article mainly introduces:

Indonesia hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Indonesia steering cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steering cylinder are widely used in Indonesia，because of high work efficiency，excellent fatigue and impact resistance，smooth movement.So our company has designed steering cylinder for customers from Indonesia.

Introduction to steering cylinder:

steering cylinder is the most important part of construction machinery, the traditional processing method is: broaching steering cylinder block - fine boring steering cylinder block - grinding steering cylinder block. The rolling method is: broaching steering cylinder block - fine boring steering cylinder block - rolling steering cylinder block, the process is 3 parts, but the time is compared: grinding 1 meter of the steering cylinder block is about 1-2 days, rolling 1 meter of the steering cylinder block is about 10-30 minutes. Input comparison: grinding machine or quilting machine (tens of thousands - millions), rolling knife (ten thousand - tens of thousands). After rolling, the surface roughness of the hole decreases from RA3.2-6.3 μm before rolling to Ra0.4 ~ 0.8μm, the surface hardness of the hole increases by about 30%, and the fatigue strength of the inner surface of the steering cylinder increases by 25%. If the steering cylinder life is only considered, it is increased by 2 to 3 times, and the boring and rolling process is 3 times more efficient than the grinding process In particular, if you want to make high-quality steering cylinders, you must take the rolling production process. After the steering cylinder is rolled, there is no sharp tiny edge on the surface, and long-term motion friction will not damage the seal ring or seal, which is particularly important in the hydraulic industry.

When the steering cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.

The oil steering cylinder is a part of the hydraulic system, in the hydraulic system, to reasonably design the heat dissipation system, to prevent the oil temperature is too high is the key to keep the hydraulic oil temperature normal. The temperature of the system should be kept in a suitable range to reduce the energy released when the bubble bursts. While not affecting the normal circulation of the coolant, a certain amount of anti-corrosion additives can be appropriately added to inhibit rust. When operating the hydraulic system, we should strive to be stable, not too fast, too strong, and try to reduce the impact of hydraulic oil on hydraulic components.

Protection of the steering cylinder surface: During the dismantling process, safety protection should be carried out on the steering cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the steering cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the steering cylinder should be cleaned up in time.

Answers to some questions about steering cylinder:

Why does the hydraulic cylinder rebound after the rod cavity is extended into place?
The reason is that after the rod cavity is extended into place, the rod cavity and the rodless cavity are connected, so that the cylinder moves towards the rod cavity. After connecting, it is equivalent to the hydraulic oil directly driving the cylinder with an area equal to the piston rod. After the end of this problem, it is estimated that the seal is not very good, and the two cavities are connected after the pressure is increased to a certain extent; Or there is a problem in the valve, so that the two chambers are connected after reaching a certain pressure. Other phenomena: If the load is increased to a certain extent, no matter which side of the solenoid valve is energized, the cylinder will move to the rod cavity.

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.