trunnion cylinder Sold to Guatemala

This article mainly introduces:

Guatemala hydraulic cylinder,trunnion cylinder manufacturer,trunnion cylinder

(Guatemala trunnion cylinder,produced by Hengyu Hydraulic Co., Ltd）

trunnion cylinder are widely used in Guatemala，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed trunnion cylinder for customers from Guatemala.

Introduction to trunnion cylinder:

When the piston speed of the trunnion cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the trunnion cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

Protection of the trunnion cylinder surface: During the dismantling process, safety protection should be carried out on the trunnion cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the trunnion cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the trunnion cylinder should be cleaned up in time.

The trunnion cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the trunnion cylinder, bite. Elimination method: When installing the trunnion cylinder, ensure that the axis position of the trunnion cylinder is consistent with the direction of movement; Make the load borne by the trunnion cylinder as far as possible through the trunnion cylinder axis, to avoid the phenomenon of eccentricity.

The assembly work of the trunnion cylinder has a great impact on the quality of the trunnion cylinder: each part must be carefully cleaned before assembly; To correctly install the sealing device everywhere: when installing the sealing ring, pay attention to its installation direction to avoid oil leakage due to installation, and its lip should be equipped with a pressure oil chamber. In addition, because it is a YX-shaped sealing ring, it is necessary to pay attention to distinguish between shaft and hole use, do not install wrong; Because the sealing device is matched with the sliding surface, an appropriate amount of hydraulic oil should be applied during assembly; The special wrench should be used when the threaded coupling is tightened, and the torque should meet the standard requirements; After the piston and piston rod are assembled, it is necessary to measure whether the coaxiality and straightness on the full length are out of whack. After assembly, there should be no blocking sensation and uneven resistance when the piston assembly moves.

Answers to some questions about trunnion cylinder:

How to calculate cylinder speed?
If there is a throttle valve, the cylinder speed will be adjustable. When the throttle is fully opened, the speed of the cylinder reaches the maximum: maximum speed = oil pump displacement ÷ cylinder cavity cross-sectional area The displacement of the oil pump is a main indicator, which can be found on the nameplate, and some can also be known by the oil pump model; The cross-sectional area of the cylinder cavity can be easily calculated. Just make sure the units are the same. And because the cross-sectional area of the rod cavity and the rodless cavity of the cylinder is different, the speed of advance and retreat may also be different.

How to choose cylinder size, pump type, motor power for a 30-ton press?
30 tons = 30,000 kg. It is expected to use a 16 mpa oil pump, then the cylinder area =30000/(160x3.14) and then square, the cylinder bore is 150 mm. Calculated at 500 mm travel per minute, the flow rate per minute is :0.75^2x3.14x5=8.8 liters/minute. Motor power =8.8x16/60=2.355. A 9 L/min, 16 mpa pump is available. Piston diameter 150 mm cylinder. 3 kW motor.