steering cylinder Sold to America

This article mainly introduces:

America hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(America steering cylinder,produced by Hebei Hengyu company）

steering cylinder are widely used in America，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed steering cylinder for customers from America.

Introduction to steering cylinder:

The steering cylinder is not the same as the steering cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the steering cylinder can not be used as a high-power power component, but the steering cylinder can be used as a relatively large power component, or the steering cylinder system can be used.

The steering cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure steering cylinder can use 20 steel pipe, and the high pressure steering cylinder can use 45 steel pipe.

The difference between the plunger steering cylinder and the piston steering cylinder is that the piston in the steering cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type steering cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

When producing oil steering cylinders, there are two processing processes, grinding and rolling, the latter is better than the former. Rolling machining is a kind of non-cutting machining, using the plastic deformation of the metal at room temperature, so that the micro roughness of the workpiece surface is flattened to achieve the purpose of changing the surface structure, mechanical characteristics, shape and size. Therefore, this method can achieve the two purposes of finishing and strengthening at the same time, which can not be done by grinding.

Answers to some questions about steering cylinder:

What is the meaning of cylinder ejection on the injection mold, and what is the difference between cylinder ejection and ordinary ejection?
Usually requires the front die ejection will use the cylinder to drive the thimble plate to achieve the ejection of the thimble. There is also a case that the mold is very large or long, and the balance of the ejector rod of the injection molding machine is not enough, and the cylinder ejector will also be used.

How to remove the lifting cylinder from the forklift truck?
The lifting cylinder is generally fixed on the door frame, and there are screws under and above it, and it is OK to loosen the screws with a wrench on the top. However, we must pay attention to ensure safety and prevent damage to the cylinder or safety accidents.