plunger type cylinder Sold to Puerto Rico

This article mainly introduces:

Puerto Rico hydraulic cylinder,plunger type cylinder manufacturer,plunger type cylinder

(Puerto Rico plunger type cylinder,produced by Hebei Hengyu company）

plunger type cylinder are widely used in Puerto Rico，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed plunger type cylinder for customers from Puerto Rico.

Introduction to plunger type cylinder:

The body of the plunger type cylinder on the processing process requirements: the body of the plunger type cylinder is an important and essential part of the plunger type cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the plunger type cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

If the seal of the plunger type cylinder is abnormal wear, you can check whether the speed control valve is improperly adjusted, resulting in too high back pressure and improper installation of the seal or hydraulic oil contamination. The second is whether there is a foreign body entering the assembly and the quality of the sealing material is not good. The result is that the action is slow and weak, and in serious cases, it will cause damage to the piston and plunger type cylinder, and the phenomenon of "pulling the plunger type cylinder" appears. The treatment method is to adjust the speed control valve, and the necessary operation and improvement should be done according to the installation instructions.

plunger type cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

If the plunger type cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

Answers to some questions about plunger type cylinder:

What are the reasons why the hydraulic cylinder action is slower than normal?
There are many factors that cause this problem. First, measure the pressure of the main system to see whether the pressure of the main system under the pressure state is consistent with the initial setting. Before measuring the pressure, it is best to check the hydraulic oil and suction oil filter and replace or clean it. Second, check the main relief valve of the reversing control multiway valve to see if there is damage or foreign matter blocking, and clean it. If your pump is a gear pump, the problem should generally be small. Second, look at traffic. There is no leakage in the cylinder, leakage in the reversing valve spool and so on.

Cylinder la-50-70st What does that mean?
Full model should be CX-LA-50-70ST, thin block cylinder, radial mounting, bore 50, stroke 70.