tailplate hydraulic cylinder Sold to Korea

This article mainly introduces:

Korea hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

(Korea tailplate hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

tailplate hydraulic cylinder are widely used in Korea，because of no need for deceleration device，no need for deceleration device，excellent temperature resistance.So our company has designed tailplate hydraulic cylinder for customers from Korea.

Introduction to tailplate hydraulic cylinder:

tailplate hydraulic cylinder abnormal sound, hysteresis phenomenon cause and elimination method: the piston rod is extended with abnormal sound and hysteresis, if the tailplate hydraulic cylinder is placed for a period of time, the tailplate hydraulic cylinder may enter the air, and the movement can be normal after dozens of repeated movements. If it still cannot be eliminated, check whether the load is aligned with the axis of the piston rod; Retracted piston rod installation helps to align the load with the piston rod. If the flow is unstable, it will also lead to abnormal movement of the piston rod. Check the relevant components of the hydraulic system.

Disassembly tailplate hydraulic cylinder: When disassembly tailplate hydraulic cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the tailplate hydraulic cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the tailplate hydraulic cylinder.

Regular maintenance of the tailplate hydraulic cylinder includes: regular tightening, tailplate hydraulic cylinder fastening screws and gland screws, tailplate hydraulic cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the tailplate hydraulic cylinder once a year. Clean regularly, the tailplate hydraulic cylinder is cleaned every other year, and the seals are replaced while cleaning.

The difference between the plunger tailplate hydraulic cylinder and the piston tailplate hydraulic cylinder is that the piston in the tailplate hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type tailplate hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

Answers to some questions about tailplate hydraulic cylinder:

What are the problems that cause hydraulic cylinder shaking?
1, the oil supply is not smooth, the hydraulic oil filter is half blocked. 2. The oil level in the oil storage tank is lower than the minimum oil level. 3, there is air in the hydraulic system. 4, the supply oil pump is damaged or not working properly. 5, the hydraulic oil is not replaced for a long time.

How to calculate hydraulic cylinder thrust?
Cylinder diameter = piston diameter =200MM Piston area =π (200/2) square =3140 square mm =31.4 square cm 25MPA=250KG/ square cm Maximum thrust = pressure * Piston area =250 *31.4 =7850KG=78500 Newtons This is the maximum thrust. The formula can be derived from the calculation formula.