steel mill cylinder Sold to Nepal

This article mainly introduces:

Nepal hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Nepal steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Nepal，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed steel mill cylinder for customers from Nepal.

Introduction to steel mill cylinder:

steel mill cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

When installing the steel mill cylinder pipe, the pipe should be cleaned after installation, and should not pass through the steel mill cylinder block, and the by-pass pipe must be installed in front of the oil port of the steel mill cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the steel mill cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the steel mill cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

The internal leakage of the steel mill cylinder is an important indicator to measure the quality of the steel mill cylinder: the internal leakage of the steel mill cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the steel mill cylinder, so that the steel mill cylinder can not accurately and stably stop in a certain position of the steel mill cylinder, so it is one of the main indicators of the steel mill cylinder.

The wear of the hard chromium plating layer of the steel mill cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

Answers to some questions about steel mill cylinder:

What is the problem that the cylinder stroke is not in place?
1. Mechanical cause: the piston rod bends; If there is a synchronous cylinder, the stroke of the two cylinders may be different. 2. Hydraulic reason: the system back pressure is too large; The actuator load increases while the system pressure decreases. The electric is not sent, the reversing valve is not reset or stuck, the oil is too dirty, there is gas in the system, the external inertia load is too large, and the cylinder stroke is not in place.

How to remove the cylinder correctly?
(1) Before disassembling the hydraulic cylinder, the hydraulic circuit should be depressurized. Otherwise, when the tubing joint connected with the cylinder is loosened, the high-pressure oil in the circuit will be quickly ejected. The hydraulic circuit of the hydraulic press should first loosen the hand wheel or pressure regulator screw at the relief valve, so that the pressure oil is unloaded, and then block the power supply or block the power source to stop the operation of the hydraulic equipment. (2) When disassembling, it should prevent damage to the top thread of the piston rod, the oil thread, the appearance of the piston rod, the inner wall of the cylinder liner, etc. In order to prevent the piston rod and other slender parts from twisting or deformation, the use of cushion wood support balance when placed. (3) Disassemble in order.