yg series hydraulic cylinder Sold to Panama

This article mainly introduces:

Panama hydraulic cylinder,yg series hydraulic cylinder manufacturer,yg series hydraulic cylinder

(Panama yg series hydraulic cylinder,produced by Hengyu Group）

yg series hydraulic cylinder are widely used in Panama，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed yg series hydraulic cylinder for customers from Panama.

Introduction to yg series hydraulic cylinder:

Causes and countermeasures of oil yg series hydraulic cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the yg series hydraulic cylinder will lead to premature wear of the piston seal, replace the piston seal; If the yg series hydraulic cylinder is visibly scarred, the yg series hydraulic cylinder must be replaced. It can be pressurized at one end of the yg series hydraulic cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most yg series hydraulic cylinder piston drift may not come from the yg series hydraulic cylinder, the above method to determine the yg series hydraulic cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.

When the oil pressure of the yg series hydraulic cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

We can not just consider the price and ignore the quality when we purchase the yg series hydraulic cylinders. Now some manufacturers produce unqualified products in order to reduce costs, the piston rod is not adjusted, the rod coating is not enough, the yg series hydraulic cylinder finish can not reach, the guide sleeve should use copper, but instead of ductile iron, although the cost is reduced, the quality of the yg series hydraulic cylinder is not required.

The machining accuracy of the yg series hydraulic cylinder depends on the level of equipment, production technology and testing means. yg series hydraulic cylinder processing methods are commonly used in two ways, one is rough boring - fine boring - rolling, generally with 45# seamless steel pipe, this method of processing quality is good, but the cost is high. Another method is to use 20# cold-drawn seamless steel pipe, and then honing, the cost is lower. The piston rod must be adjusted and straightened before processing, and the coating thickness of the piston rod is generally not less than 0.03mm. The piston must be machined in strict accordance with the groove size and tolerance requirements given in the seal manual.

Answers to some questions about yg series hydraulic cylinder:

What are the problems that cause hydraulic cylinder shaking?
1, the oil supply is not smooth, the hydraulic oil filter is half blocked. 2. The oil level in the oil storage tank is lower than the minimum oil level. 3, there is air in the hydraulic system. 4, the supply oil pump is damaged or not working properly. 5, the hydraulic oil is not replaced for a long time.

Why the cylinder cannot operate normally after the explosion-proof valve is installed?
The pipeline explosion-proof valve is specially designed to prevent pipeline damage and free fall of the cylinder, so there must be back pressure to open. If there is no oil return pressure, or the oil return pressure is too small, and can not adjust the oil return pressure, such a system with explosion-proof valves is more troublesome, it is recommended to add a one-way throttle valve between the cylinder and the tank to establish back pressure. If you understand the explosion-proof valve, you can also try to adjust the opening of the valve (that is, the flow of the regulating valve), and adjust the opening to help the valve to open.