forklift steering cylinder Sold to Tanzania

This article mainly introduces:

Tanzania hydraulic cylinder,forklift steering cylinder manufacturer,forklift steering cylinder

(Tanzania forklift steering cylinder,produced by Hebei Hengyu company）

forklift steering cylinder are widely used in Tanzania，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed forklift steering cylinder for customers from Tanzania.

Introduction to forklift steering cylinder:

When the hydraulic oil is not pumped into the forklift steering cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the forklift steering cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

forklift steering cylinder body inspection: The inner surface of the forklift steering cylinder and the piston seal are the main factors causing the leakage in the forklift steering cylinder, if the forklift steering cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the forklift steering cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

forklift steering cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards forklift steering cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the forklift steering cylinder guide is determined by the length of the stroke. Check the strength of forklift steering cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

In use, the forklift steering cylinder should try to avoid the friction iron powder or iron filings formed by buffering the plunger. When the matching gap of the buffer device is small and the transverse load on the piston rod is large, the sintering phenomenon may be caused. These friction iron powder or the metal fragments that have fallen off as a result of sintering will remain in the forklift steering cylinder.

Answers to some questions about forklift steering cylinder:

What is the material of the cylinder support ring?
Generally, it is polytetrafluoroethylene doped with copper powder, or polyformaldehyde, and copper sleeves, there are also nylon, resin and so on.

Does the sealing string of the upper and lower chamber of the hydraulic cylinder fall by itself?
It is possible, the probability accounts for 85% (depending on the weight), the weight is less than the system resistance, may not fall, the weight is greater than the system resistance, will not necessarily fall, so often check the equipment, safety first, find the problem in time to solve, the cylinder is not very expensive parts, maintenance does not cost much money, However, accidents caused by cylinder failure will lose several times the cost.