yg series hydraulic cylinder Sold to Cote d 'Ivoire

This article mainly introduces:

Cote d 'Ivoire hydraulic cylinder,yg series hydraulic cylinder manufacturer,yg series hydraulic cylinder

(Cote d 'Ivoire yg series hydraulic cylinder,produced by Hengyu Group）

yg series hydraulic cylinder are widely used in Cote d 'Ivoire，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed yg series hydraulic cylinder for customers from Cote d 'Ivoire.

Introduction to yg series hydraulic cylinder:

When the piston speed of the yg series hydraulic cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the yg series hydraulic cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

The main role of the yg series hydraulic cylinder: the yg series hydraulic cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the yg series hydraulic cylinder realizes reciprocating motion. The structure of the yg series hydraulic cylinder has three categories: piston yg series hydraulic cylinder, plunger yg series hydraulic cylinder, swing yg series hydraulic cylinder, piston yg series hydraulic cylinder and plunger yg series hydraulic cylinder to achieve reciprocating linear motion, output speed and thrust, swing yg series hydraulic cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the yg series hydraulic cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The yg series hydraulic cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

When the yg series hydraulic cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the yg series hydraulic cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.

If air enters the hydraulic system, the yg series hydraulic cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

Answers to some questions about yg series hydraulic cylinder:

How to deal with hydraulic cylinder inner wall rag, local wear serious or corrosion?
It can be reparied if the inner wall of the hydraulic cylinder is frayed, local wear or corrosion. We can use the inner wall cold melting copper technology, it has the following advantages: first, the temperature is low, the operating temperature is less than 180 degrees, and the heat affected zone is small. Second: high hardness is up to Brinell hardness 280, wear resistance and anti-corrosion. Third: the process is mature, some large coal mills have been repaired with this method and the effect is remarkable.

How to control the speed of the hydraulic cylinder?
The speed of the hydraulic cylinder is only related to the flow, so the control speed is to control the flow of the hydraulic oil, which is generally adjusted by the throttle valve in the system.