electromagnetic induction cylinder Sold to Romania

This article mainly introduces:

Romania hydraulic cylinder,electromagnetic induction cylinder manufacturer,electromagnetic induction cylinder

(Romania electromagnetic induction cylinder,produced by Hengyu Group）

electromagnetic induction cylinder are widely used in Romania，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed electromagnetic induction cylinder for customers from Romania.

Introduction to electromagnetic induction cylinder:

electromagnetic induction cylinder buffer valve inspection and maintenance: For the valve buffer electromagnetic induction cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

Regular maintenance of the electromagnetic induction cylinder includes: regular tightening, electromagnetic induction cylinder fastening screws and gland screws, electromagnetic induction cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the electromagnetic induction cylinder once a year. Clean regularly, the electromagnetic induction cylinder is cleaned every other year, and the seals are replaced while cleaning.

In the process of using the electromagnetic induction cylinder, sometimes such a problem will occur, the electromagnetic induction cylinder can not act immediately after the instruction of the electromagnetic induction cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil electromagnetic induction cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

When the electromagnetic induction cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the electromagnetic induction cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

Answers to some questions about electromagnetic induction cylinder:

What hydraulic oil does servo cylinder generally use?
The medium used by the cylinder generally depends on the working condition of the use, including pressure, installation environment, sealing material, etc. I think the first thing to consider is the impact of the sealing material. Mineral oil is a good choice if it is not too fire-resistant or used in a high temperature environment. 1, servo cylinder features: closed-loop servo control, control accuracy of 0.01mm; Precise control of thrust, increase pressure sensor, control accuracy up to 1%; It is easy to connect with PLC and other control systems to achieve high precision motion control. Low noise, energy saving, clean, high rigidity, impact resistance, long life, simple operation and maintenance. 2, the servo cylinder can be fault-free in harsh environments, and the protection level can reach IP66.

What is a differential cylinder?
The differential cylinder is by connecting the return oil of the rod cavity through the pipeline, allowing them to flow into the rodless cavity, thereby speeding up the extension speed of the piston rod. In fact, the cylinder is still the cylinder, but the oil circuit is related to the connection. The oil connection mode in which both chambers of a single rod hydraulic cylinder are fed hydraulic oil is called differential connection.