Release time：2023-11-12 15:30:12 Hits： Current position: Home > News
This article mainly introduces:
Uzbekistan hydraulic cylinder,moving truck hydraulic cylinder manufacturer,moving truck hydraulic cylinder
(Uzbekistan moving truck hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）
moving truck hydraulic cylinder are widely used in Uzbekistan，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed moving truck hydraulic cylinder for customers from Uzbekistan.
moving truck hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. moving truck hydraulic cylinder selection specifications are too small. Leakage in moving truck hydraulic cylinder or associated hydraulic system element.
When the oil pressure of the moving truck hydraulic cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.
The repair method of the moving truck hydraulic cylinder: the repair of the moving truck hydraulic cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.
The moving truck hydraulic cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.
What size of hydraulic cylinder is needed for 200 tons pressure? The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate by the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the pressure level P (unit MPa) when working, then the thrust of the cylinder F push =3.14*R*R*P (unit N) the pull of the cylinder F pull =3.14* (R* R-R *R) *P (unit N) 100 tons of the cylinder, System pressure 16Mpa.
How to remove the lifting cylinder from the forklift truck?
The lifting cylinder is generally fixed on the door frame, and there are screws under and above it, and it is OK to loosen the screws with a wrench on the top. However, we must pay attention to ensure safety and prevent damage to the cylinder or safety accidents.
Add Wechat