cylinder with hydraulic lock Sold to Turkmenistan

This article mainly introduces:

Turkmenistan hydraulic cylinder,cylinder with hydraulic lock manufacturer,cylinder with hydraulic lock

(Turkmenistan cylinder with hydraulic lock,produced by Hebei Hengyu company）

cylinder with hydraulic lock are widely used in Turkmenistan，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed cylinder with hydraulic lock for customers from Turkmenistan.

Introduction to cylinder with hydraulic lock:

The "O" ring can be used as an auxiliary seal inside the cylinder with hydraulic lock, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the cylinder with hydraulic lock, and can be completely sealed.

The daily inspection of the cylinder with hydraulic lock includes: checking the connection of the cylinder with hydraulic lock and the pipe joint for leaks. Check the cylinder with hydraulic lock rod for leaks. Check the cylinder with hydraulic lock connection for leaks. When the cylinder with hydraulic lock moves, the work is normal and smooth. Whether the cylinder with hydraulic lock has internal leakage.

cylinder with hydraulic lock seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the cylinder with hydraulic lock seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the cylinder with hydraulic lock. c. The cylinder with hydraulic lock seal is extruded, if the O-ring is obviously extruded at the cylinder with hydraulic lock seal, replace the cylinder with hydraulic lock seal.

The internal leakage of the cylinder with hydraulic lock should be prevented when the cylinder with hydraulic lock is used. The internal leakage of cylinder with hydraulic lock includes the leakage caused by excessive wear of cylinder with hydraulic lock block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

Answers to some questions about cylinder with hydraulic lock:

How many kinds of cylinder seal repair kit are there?
Very much, a wide variety of imported and domestic, J type, UHS, DHS, O-ring, Sterseal, etc., as well as support bars, materials are different, according to the size of the pressure selection is different, the appearance of the structure is different, the size is a variety, maintenance is generally selected according to the needs of the cylinder.

Why does the hydraulic cylinder go up to the top and then slowly go down?
Leakage in the cylinder or the hydraulic valve that controls the cylinder, can be replaced and removed. Or add a pressure retaining valve to the hydraulic system to ensure pressure.