This article mainly introduces:
Ecuador hydraulic cylinder,rack cylinder manufacturer,rack cylinder
(Ecuador rack cylinder,produced by Hengyu Group）
rack cylinder are widely used in Ecuador，because of excellent fatigue and impact resistance，smooth movement，high work efficiency.So our company has designed rack cylinder for customers from Ecuador.
rack cylinder can not drive the load troubleshooting: oil pressure is too low. rack cylinder selection specifications are too small. Leakage in rack cylinder or associated hydraulic system element.
Because of the slightly complex structure of the buffer rack cylinder, sometimes there will be problems, such as when the rack cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.
When the piston speed of the rack cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the rack cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.
When producing oil rack cylinders, there are two processing processes, grinding and rolling, the latter is better than the former. Rolling machining is a kind of non-cutting machining, using the plastic deformation of the metal at room temperature, so that the micro roughness of the workpiece surface is flattened to achieve the purpose of changing the surface structure, mechanical characteristics, shape and size. Therefore, this method can achieve the two purposes of finishing and strengthening at the same time, which can not be done by grinding.
What parameters do I need to provide when purchasing hydraulic cylinders?
The main technical parameters of the hydraulic cylinder: 1. Cylinder diameter; Cylinder diameter, inner diameter size; 2. Piston rod diameter; 3. Cylinder stroke; 4. Cylinder pressure; The working pressure of the cylinder is often calculated using the test pressure, which is less than 16MPa multiplied by 1.5 and higher than 16 multiplied by 1.255. Import and export diameter and thread parameters; 6. Whether there is buffer; According to the working conditions, the piston rod extension contraction is generally buffered if the impact is large. 7. Installation method of oil cylinder, etc.
How many tons can a 10mpa cylinder with a diameter of 100 hold up?
About 8 tons. Algorithm: Cylinder cross-sectional area = π* (100/2) ^2=3.14*2500=7850 square mm = 0.00785 square meters pressure = pressure * Cross-sectional area = 10000000Pa*0.00785 square meters = 78500 n mass = pressure /g = 78500 N ÷9.8 n/kg = 8010 kg = 8.01 Tons.
Add Wechat