steel mill cylinder Sold to Britain

This article mainly introduces:

Britain hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Britain steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Britain，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed steel mill cylinder for customers from Britain.

Introduction to steel mill cylinder:

steel mill cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards steel mill cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the steel mill cylinder guide is determined by the length of the stroke. Check the strength of steel mill cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

steel mill cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the steel mill cylinder head itself is the guide sleeve of the piston rod, the steel mill cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the steel mill cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

When using the steel mill cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the steel mill cylinder block. If the steel mill cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the steel mill cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the steel mill cylinder, so that the working efficiency of the steel mill cylinder is reduced.

When the steel mill cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the steel mill cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil steel mill cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical steel mill cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the steel mill cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

Answers to some questions about steel mill cylinder:

What are the connection methods of the hydraulic cylinder? The connection modes of the cylinder and the actuator are earring connection, hinge shaft connection, thread connection, etc. The connection modes of tubing and cylinder are threaded connection, flange connection, etc.

What are the problems that cause hydraulic cylinder shaking?
1, the oil supply is not smooth, the hydraulic oil filter is half blocked. 2. The oil level in the oil storage tank is lower than the minimum oil level. 3, there is air in the hydraulic system. 4, the supply oil pump is damaged or not working properly. 5, the hydraulic oil is not replaced for a long time.