tailplate hydraulic cylinder Sold to Panama

This article mainly introduces:

Panama hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

(Panama tailplate hydraulic cylinder,produced by Hebei Hengyu company）

tailplate hydraulic cylinder are widely used in Panama，because of excellent temperature resistance，powerful torque，no need for deceleration device.So our company has designed tailplate hydraulic cylinder for customers from Panama.

Introduction to tailplate hydraulic cylinder:

The tailplate hydraulic cylinder body is commonly made of No. 20, 35, 45 seamless steel pipe, and the steel pipe is honed or rolled to achieve the roughness requirement within 0.4μm. The low pressure tailplate hydraulic cylinder can use 20 steel pipe, and the high pressure tailplate hydraulic cylinder can use 45 steel pipe.

How the cavitation of the tailplate hydraulic cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the tailplate hydraulic cylinder, resulting in corrosive damage to the parts.

Disassembly tailplate hydraulic cylinder: When disassembly tailplate hydraulic cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the tailplate hydraulic cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the tailplate hydraulic cylinder.

If air enters the hydraulic system, the tailplate hydraulic cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

Answers to some questions about tailplate hydraulic cylinder:

What's the use of three oil pipes on the cylinder?
The cylinder usually has an upper and lower oil chamber, one is connected to the upper oil chamber, one is connected to the lower oil chamber, sometimes a hydraulic lock will be added, that is, a hydraulic control check valve to prevent accidents when the oil pipe breaks, so the third pipe should be the control oil pipe of the hydraulic control check valve.

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.