Release time：2023-11-12 15:27:01 Hits： Current position: Home > News
This article mainly introduces:
Mexico hydraulic cylinder,roller press hydraulic cylinder manufacturer,roller press hydraulic cylinder
(Mexico roller press hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）
roller press hydraulic cylinder are widely used in Mexico，because of long service life，smooth movement，high work efficiency.So our company has designed roller press hydraulic cylinder for customers from Mexico.
roller press hydraulic cylinder piston sealing is best to use Yx ring, polyurethane and polytetrafluoroethylene sealing material combination, can significantly improve the sealing performance: (I), reduce friction resistance, no crawling phenomenon; (ii) Have good dynamic and static sealing, wear resistance, long service life; (iii) The installation groove is simple, and the disassembly is simple.
How to repair the roller press hydraulic cylinder body when it is damaged: When the roller press hydraulic cylinder has trace deformation and shallow tensile marks, the roller press hydraulic cylinder is repaired by strong honing process. The heavy honing process can repair roller press hydraulic cylinders up to 2.5 times out of tolerance than the original tolerance. It honed the parts with excessive size or shape error through a powerful honing machine, so that the overall size, shape tolerance and roughness of the roller press hydraulic cylinder can meet the technical requirements.
When the roller press hydraulic cylinder is repaired, its inner and outer diameter and roundness should be accurately measured. If the inner hole of the roller press hydraulic cylinder is badly worn, it can be repaired by grinding the mandrel or honing on the boring machine. If the piston is worn, it can be repaired by electroplating, and serious wear should be replaced.
The machining accuracy of the roller press hydraulic cylinder depends on the level of equipment, production technology and testing means. roller press hydraulic cylinder processing methods are commonly used in two ways, one is rough boring - fine boring - rolling, generally with 45# seamless steel pipe, this method of processing quality is good, but the cost is high. Another method is to use 20# cold-drawn seamless steel pipe, and then honing, the cost is lower. The piston rod must be adjusted and straightened before processing, and the coating thickness of the piston rod is generally not less than 0.03mm. The piston must be machined in strict accordance with the groove size and tolerance requirements given in the seal manual.
What is the clearance between the cylinder and the piston?
The gap between the cylinder and the piston in the radius is generally 40 wires, that is, about 0.4mm, and the gap of the cylinder with different diameters will be slightly different. Generally, the inner diameter of the cylinder is larger than the outer diameter of the piston, so as to prevent the friction between the outer surface and the inner surface of the cylinder during the operation of the piston. In order to ensure that the cylinder has a rod cavity and a rodless cavity seal, a sealing device, that is, a sealing ring, is installed on the outer surface of the piston. The sealing ring form is not exactly the same, the O-type sealing ring is generally used under low pressure, and the lip sealing ring is used under high pressure. At the same time, the outer circle of the piston is also equipped with a dust ring and a wear ring. As long as the cylinder seal fails, all the internal seals should be replaced.
When the cylinder is tested, why can't the pressure be maintained with the balance valve?
Because the oil into the oil chamber through the hydraulic lock on the control oil circuit through the other side of the spool, the original valve is designed in this way. It locks the circuit after the oil supply circuit loses pressure, on the contrary, if you keep supplying pressure, it is always in the state of opening the other side of the one-way spool. So this valve can't be used in the test.
Add Wechat