single rack cylinder Sold to Ecuador

This article mainly introduces:

Ecuador hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Ecuador single rack cylinder,produced by Hebei Hengyu company）

single rack cylinder are widely used in Ecuador，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed single rack cylinder for customers from Ecuador.

Introduction to single rack cylinder:

The method of sleeve single rack cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the single rack cylinder can be significantly improved by rolling in the finishing of the inner holes of the single rack cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.

single rack cylinder can not drive the load troubleshooting: oil pressure is too low. single rack cylinder selection specifications are too small. Leakage in single rack cylinder or associated hydraulic system element.

The scar on the sliding surface of the single rack cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the single rack cylinder wall. Therefore, before installation, these scars must be fully repaired.

Most of the failure of the single rack cylinder is because there is a foreign body in the single rack cylinder into the failure of the single rack cylinder, the most problematic is that it is difficult to determine when the foreign body is into the single rack cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about single rack cylinder:

What is a hydraulic cylinder assembly?
Assembly, which means aggregate. A series of parts or products, formed to achieve a specific function of the whole, the general term for this system is assembly. The hydraulic cylinder assembly is not a single hydraulic cylinder part, which can be used by connecting the hydraulic hose.

How to calculate the inner diameter of the hydraulic cylinder?
These two parameters need the following information to decide: 1, pump displacement, speed (to get the actual output flow of the pump) 2, three and time requirements (lift time, drop time takes a few seconds) and then view the close cylinder series according to the results. Select the right cylinder.