stacker cylinder Sold to Luxembourg

This article mainly introduces:

Luxembourg hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Luxembourg stacker cylinder,produced by Hebei Hengyu company）

stacker cylinder are widely used in Luxembourg，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed stacker cylinder for customers from Luxembourg.

Introduction to stacker cylinder:

The piston rod of the stacker cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.

When the stacker cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the stacker cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

The stacker cylinder should be vented: when the stacker cylinder is installed or parked for a long time to work again, the air will penetrate into the stacker cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the stacker cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the stacker cylinder, the oil is best entered and discharged from the highest point of the stacker cylinder. stacker cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

When the stacker cylinder is installed, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the stacker cylinder head, earring (or middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent rigid interference and cause unnecessary damage.

Answers to some questions about stacker cylinder:

For a cylinder with a piston diameter of 100mm and a system pressure of 10MPa, what is the thrust?
Thrust is 7850 kg. Piston area A= πR^2=7850 square mm =78.5 square cm 10MPa = 100kg/cm^2 "^2" is square F = A x P =78.5 x 100=7850 kg.

Is a hydraulic cylinder and a jack the same thing?
Strictly speaking, no. Although the hydraulic principle is used, and even some of the longer jacks are similar to the cylinder, the internal structure of the two is different. There is a check valve inside the jack. After the top lift, the check valve locks the hydraulic oil circuit, and the hydraulic oil only enters and does not exit after the check valve locks, and can be lowered to complete a reciprocating movement. The cylinder is usually connected to the distribution tube to control the movement, and works with a wide variety of distribution valves and distribution systems according to different needs. The jack only needs a simple check valve.