Release time：2023-11-12 15:26:42 Hits： Current position: Home > News
This article mainly introduces:
Pakistan hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder
(Pakistan trailer hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）
trailer hydraulic cylinder are widely used in Pakistan，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed trailer hydraulic cylinder for customers from Pakistan.
trailer hydraulic cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the trailer hydraulic cylinder head itself is the guide sleeve of the piston rod, the trailer hydraulic cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the trailer hydraulic cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.
If the seal of the trailer hydraulic cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.
Analysis of commonly used seals: The wear ring and slip ring commonly used on the trailer hydraulic cylinder are generally made of polytetrafluoroethylene + graphite, because pure polytetrafluoroethylene is easy to produce plastic creep, which is only suitable for low pressure and low wear resistance conditions. If the sealing ring used is a composite material formed after adding graphite filler, the performance can be effectively improved, the ability to resist plastic creep is increased by 2 to 3 times, the initial deformation caused by the load is reduced by 30 to 60% : the rigidity is increased by 2 to 3 times: the dimensional stability under heat is increased by 2 times, and the hardness is increased by l0 to 15%.
The trailer hydraulic cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.
How to remove the lifting cylinder from the forklift truck?
The lifting cylinder is generally fixed on the door frame, and there are screws under and above it, and it is OK to loosen the screws with a wrench on the top. However, we must pay attention to ensure safety and prevent damage to the cylinder or safety accidents.
Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.
Add Wechat