rolling mill cylinder(rolling mill cylinder,produced by Hengyu Hydraulic Cylinder Factory）rolling mill cylinder are widely used ，because of smooth movement，high work efficiency，excellent
(rolling mill cylinder,produced by Hengyu Hydraulic Cylinder Factory）
rolling mill cylinder are widely used ，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed rolling mill cylinder for our customers.
When the rolling mill cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.
The viscosity of the working oil used in the rolling mill cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.
The method of sleeve rolling mill cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the rolling mill cylinder can be significantly improved by rolling in the finishing of the inner holes of the rolling mill cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.
When the rolling mill cylinder is installed, the piston and the rolling mill cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the rolling mill cylinder head boss is easy to cause scars when it hits the inner surface of the rolling mill cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized rolling mill cylinders, only careful and careful operation can be avoided.
Is a hydraulic cylinder and a jack the same thing?
Strictly speaking, no. Although the hydraulic principle is used, and even some of the longer jacks are similar to the cylinder, the internal structure of the two is different. There is a check valve inside the jack. After the top lift, the check valve locks the hydraulic oil circuit, and the hydraulic oil only enters and does not exit after the check valve locks, and can be lowered to complete a reciprocating movement. The cylinder is usually connected to the distribution tube to control the movement, and works with a wide variety of distribution valves and distribution systems according to different needs. The jack only needs a simple check valve.
Why is the cylinder not in place when the concrete pump truck changes the piston?
When the concrete pump truck changes the piston, the cylinder is not in place mainly because the transfer oil connecting the two cylinders is not completely drained. Sany and Zhonglian have a piston return switch, which can be used to back the piston to the cleaning tank. The elephant is equipped with a stop valve at the bottom of the oil cylinder, usually in the closed state, when opened, the piston can be returned to the cleaning tank, remember to close the valve after the piston is updated.
Add Wechat